Sign-Up

How to make square origami envelopes

How to make origami a card case

How to cut a Kirigami Flower

‹ ›

Might be of interest to you.

How to make filigree jewelry from paper bags
By: papersculpture

How to make a bracelet with a hole puncher and scrap paper
By: papersculpture

How to make round beads from rolled up strips of paper
By: papersculpture

How to make a lizard from beads.

By: papersculpture

Home page >> Guides >> Games and Hobbies >> Crafts >> Jewelry >> How to make a bracelet or napkin ring from paper strips

Games and Hobbies

How to make a bracelet or napkin ring from paper strips

12/25/2016 6:02:10 PM
By: papersculpture
Beginner

Ranking:

(0 Ranks)

With a few strips of paper you can make this easy and impressive bracelet or napkin ring.

Difficulty level: Beginners

Instructions:

<p> Materials:</p>
<p> Paper</p>
<p> Scissors</p>
<p> Paper glue</p>
<p> </p>

Materials:
Paper
Scissors
Paper glue

<p> Cut 1 strip 2 cm wide and long enough to go around your fist with a slight overlap.</p>
<p> Cut strips 1 cm wide</p>
<p> *Any width can be used for the band and 1 / 2 the width for the strips.</p>
<p> </p>

Cut 1 strip 2 cm wide and long enough to go around your fist with a slight overlap.
Cut strips 1 cm wide
*Any width can be used for the band and 1 / 2 the width for the strips.

<p> Glue the thicker strip into a band that can slide over your fist.</p>
<p> Align and glue a thin strip to the inside of the band.</p>
<p> </p>

Glue the thicker strip into a band that can slide over your fist.
Align and glue a thin strip to the inside of the band.

<p> Turn the band so that the thin strip is on the right side.</p>
<p> Fold the top edge of the thin strip down to align with the right side of the band.</p>
<p> </p>

Turn the band so that the thin strip is on the right side.
Fold the top edge of the thin strip down to align with the right side of the band.

<p> Result</p>
<p> Fold the strip to the left and over the edge.</p>
<p> </p>

Result
Fold the strip to the left and over the edge.

Fold the right side of the strip up to align with the bottom of the triangle.

Fold the strip backwards along the left edge of the band.

Result

Repeat steps 4 to 8.

<p> The last fold before gluing a new strip should be to the back.</p>
<p> Cut off the extra behind the right edge.</p>

The last fold before gluing a new strip should be to the back.
Cut off the extra behind the right edge.

Unfold the last fold. Align and glue the new strip on the left side of the crease.

<p> When you have completely covered the band, the last strip should align inside of the band.</p>
<p> Unfold the last fold, put glue on it and refold.</p>
<p> </p>

When you have completely covered the band, the last strip should align inside of the band.
Unfold the last fold, put glue on it and refold.

Enjoy your finished bracelet!

Add to Favorites Send to a friend Print this guide

Saw something you liked? Have a question? Write a comment

If you don't want to leave a comment via Facebook:

Might interest you:

How to make filigree jewelry from paper bags

How to make a bracelet with a hole puncher and scrap paper

How to make round beads from rolled up strips of paper